Tuesday, 6 December 2016

Moto E3 [Unbrick] How to install Stock Firmware on Moto E3 Power


Download and install Stock rom on Moto E3 Power [XT1706].So if you want to restore the stock firmware of Moto E2, then you came at right place today we are going to tell you how to restore the stock firmware of Moto E3 .I tell you how to unbrick a soft brick Moto E3 Power by installing stock rom.



After you have successfully Rooted and installed TWRP recovery on Moto E3 then download the Stock firmware files from below.

Requirements

  1. Backup your important apps , messages and contacts.
  2. Charge your mobile up to 80%.
  3. Do not try this installation guide on any other Android device.
  4. Follow the above guide first before jumping to this one.
  5. You must have TWRP recovery installed in Moto E3 Power


Downloads -

How to Install Stock Firmware on Moto E3 Power

  • First of all download Moto E3 Stock firmware files from above.
  • Now unzip the zip files
  • Copy the zip files in your mobile SD card/internal memory.
  • Now boot your mobile into recovery mode by pressing and holding Volume up and power button at the same time.
  • Now in TWRP recovery your screen will look like this
  • Then Tap on the wipe and do wipe data factory reset and wipe cache partition.
  • Go back and tap on Install
  • Now select the zip file which you have copied in your mobile SD Card/Internal Memory.
  • Flash the file and wait until the installation got done.
  • Reboot your device after that.
  • Done..

1 comment:

  1. After that mobile is not powering up. Plz help

    ReplyDelete

One tech spot for Android rooting, Modes WhatsApp tech news , CyanogenMod updates, latest games apk